Features
- This is a puller that has a separator attached to the back of the bearing and pulls out the bearing.
- SKF TMBS Heavy Duty Back Pullers simplify bearing removal when the space behind the bearing is limited by traditional jaw pullers or in applications where long reach is required.
- It features a special separator design that can be easily inserted between the bearing and shaft shoulder.
Purpose
- For easy removal of bearings and parts.
- Especially for large diameter shafts.
Specifications in detail
Easy to place separator between bearing and shaft shoulderEspecially
suitable for large shaftsSpring
-loaded centre point in spindle makes it easy to centre the puller and minimises the risk of shaft damageHydraulic
spindle with safety valve
for safe and easy removalFirm grip on the rear of the bearing inner ring reduces the force required to remove the bearing2 hydraulic
for safe and easy removalFirm grip on the rear of the bearing inner ring reduces the force required to remove the bearing2
hydraulic
spindle extensions and extension rods allow quick adaptation to the required pull length up to 816 mmRear
puller typeHydraulicPiston stroke (mm): 80Pulling bearing outer diameter (mm): ~ 215Pulling bearing inner diameter (mm): 35-150Jaw reach (mm): 120-816Jaw tip thickness (mm): 12 (max) Set contents (pieces): 14Proof load (kN): 100Push screw hex size (mm): Handle type ^
puller typeHydraulicPiston
stroke (mm):
80Pulling bearing outer diameter (mm): ~ 215Pulling
bearing inner diameter (mm): 35-150Jaw
reach (mm): 120-816Jaw
tip thickness (mm): 12 (max)
Set contents (pieces): 14Proof
load (kN): 100Push
screw hex size (mm): Handle type
^
SKF TMBS 150E
