- It can be clamped quickly and manually using a bolt or clamp lever.
- It is compact and can be clamped in a small space.
- The height adjustment cylinder makes it easy to clamp at high positions.
Specifications in detail
The clamping position can be infinitely adjusted using the positioning ring EH23310.0350, allowing the clamping arm to be repeatedly brought to the same position.
If a positioning ring is used, dimension h2 will be increased by 7 mm (stroke s will be minus 7 mm).
There are two fixing methods: using T-slot and T-nut (DIN508).
It is fixed directly to the jig's base plate etc. using bolts.
Make sure the entire bottom of the clamp is in contact with a flat surface.
The clamp height is limited to not exceed h1.
Please refer to the height adjustment cylinder EH-23310. and spacer plates EH-1107. and EH1108. to accommodate clamping at higher positions.
In addition, when clamping at a low position, it is possible to attach a oscillating pad such as EH-22730.
Maximum holding force: 10kN
Height (mm): Max 134.0
Clamping force (N): 10000
Turning direction and angle: 360° left and right
Stroke (mm): 30
Mounting screw (mm): M12
d=40mm / h1 max.=98mm
HALDER 23310.0054
